Sinister Speed Shop
The Original Ford Bronco Cargo Area Gear Hooks - Only Fits 4-door Broncos with Roll Bar Mounts
The Original Ford Bronco Cargo Area Gear Hooks - Only Fits 4-door Broncos with Roll Bar Mounts
Couldn't load pickup availability
- PROUDLY MADE IN TEXAS
**NOTE: Please check your roll bar first and make sure you have a threaded hole on the inside portion of your roll bar as shown in the pictures above before ordering**
**Does NOT fit two-door Broncos or Bronco Raptors.** Only the 'Speaker Mount' Gear Hooks fit the two-door Broncos and Bronco Raptors.
Early production four-door Broncos do not have this roll bar mount, but we do offer a different design that should fit every Bronco produced so far: SPEAKER MOUNT
The original Bronco gear hook, this set is exclusively designed for the 2021+ full-size four-door Ford Bronco! Unlike competitors, our hooks have been engineered and vetted to hold 20 pounds (per hook), and include a custom-molded rubber backing to help grip and provide a soft mating surface against the roll bar.
Our gear hooks are made with a High-Modulus Carbon Fiber filament that not only looks great but is also as rugged as the vehicle they are bolted to! Since the Bronco does not come equipped with a garment hook typically found in most vehicles, these custom-made hooks bolt directly to pre-existing holes on the rear roll bar of the Bronco and provide an easy way to hang your dry cleaning, jackets, hats, bags, backpacks, etc.
*Lifetime warranty* - see warranty page on site for details.
Collapsible content
DETAILS
Each set of hooks also includes a custom-molded rubber backing to help grip and provide a soft mating surface against the roll bar.
These hooks are only designed to fit the FULL-SIZE Bronco and do NOT fit the Bronco Sport.
Each order includes two gear hooks and T40 Torx head mounting bolts.
All parts are custom designed and manufactured in the USA by Sinister CNC.
INSTALLATION TIPS
Roll Bar Mount Install
Use a Torx T40 (Torx Plus 30 or IP30) driver to install the included roll bar hook bolts. If you have the factory tool kit that comes with the Bronco an IP30 Torx bit and driver can be found there. Check that the hook is level with the floor of the cargo area before tightening. Do NOT over tighten the bolt as it just needs enough torque so that the hook doesn’t wiggle. Repeat this process for the other side and you’re done!