2021+ Ford Bronco Garment + Gear Hook Combo Pack

NOTE: BOTH the garment and speaker mount gear hooks are designed ONLY to fit the 2021+ FULL-SIZE Bronco and Bronco Raptor and do NOT fit the Bronco Sport.

Garment Hook Details:
Since the Ford Bronco does not come equipped with a garment hook typically found in most vehicles, these custom-made hooks bolt directly to the roll bar above the window on each side of the backseat in a Bronco and provide an easy way to hang your shirts, dry-cleaned clothes, jackets, etc.

Each order includes two hooks, one for each side of the vehicle. Just remove the factory bolt holding on the roll bar trim, install the garment hook, and screw the bolt back in. Repeat the process on the other side and you're done!

Gear Hook Details:
The original Bronco gear hook, this set, unlike competitors, has been engineered and vetted to hold 20 pounds (per hook), and includes a custom-molded rubber backing to help grip and provide a soft mating surface against the roll bar.

Our gear hooks bolt directly to pre-existing holes on the rear roll bar of the Bronco and provide an easy way to hang your bags, backpacks, groceries, jackets, hats, etc. These are truly a must-have Ford Bronco accessory!

This set of hooks is designed to fit all full-size two-door and four-door Broncos that have speakers mounted to the rear roll bar. Just remove the lower speaker mounting bolt with a T30 Torx bit, install the gear hook and screw the bolt back in. Repeat the process on the other side and you're done!

*Pro Tip* Use an extendable clothes bar or rod from hook to hook to hang more stuff! Extendable clothes rods with metal swivel hangers and twist-lock bars provide the best fit:

Here are links to the clothes bar shown in our photos:

Amazon | O'Reilly Auto Parts

All parts are custom designed and manufactured in the USA by Sinister CNC.

Gear Hook Speaker Mount Install

Remove the lower bolt that mounts the speaker to the roll bar with a Torx Plus 30 driver (aka IP30 or TP30. If you have the factory tool kit for the Bronco this Torx bit is included.

There is a matte and a shiny side to the gear hooks. Choose which side you want facing the rear of the vehicle. Two rubber pads are included if you want to install them on the backs of the hooks that touch the roll bar. Begin by threading the speaker bolt you removed into the gear hook. Hold the gear hook up to the speaker mounting hole and thread the bolt all the way in. Check that the hook is level with the floor of the cargo area before tightening all the way. Don’t over tighten the bolt as it just needs enough torque so that the hook doesn’t wiggle. Repeat this process for the other side and you’re done!

Garment Hook Install

Remove the factory bolt holding on the roll bar trim, install the garment hook, and screw the bolt back in. Repeat the process on the other side and you're done!